Ok. Ima dumb but can not figure out how to get the stand alone (preordered) version of korea to open in steam frame Worked fine with my G2, but refuses to open now.
What am I missing??
Not well explianed. If u use the wizard (can not see how to set up other wise) you can opt to use presets. Great. Except you still get dumped into an assignment screen. With no option to skip.
Once u have assigned I can not find a way to clear the controls to start over. When I try, I get "button alread assigned" warnings.
So I appear to be stuck.
Help!!
Anyone know if they will ever tun it back on, or why its non functional?
Printing with a saturn 16k, using ABS like resin. Only real issue before this was deformaty on long thin prints, like a axe handle or sniper rifle barrel on minis. They sometimes come out....flat.
Have a larger presupported bust from a very well known and reputable source. Its a Bust and a base, both at angle. The bust printed fine.
The base however fails after it prints about 3 MM. I ran the tank cleaner for 30 sec and was able to peel the failed print off. The base portion is just raised enough above the cured rectangle to catch a spatulas edge.
Next print did same thing. I think Its failing about layer 10 or 20.
I am going to move the print from the build plate center toward one side and try again.
Beside this. Any thoughts?
Printing with a saturn 16k, using ABS like resin. Only real issue before this was deformaty on long thin prints, like a axe handle or sniper rifle barrel on minis. They sometimes come out....flat.
Have a larger presupported bust from a very well known and reputable source. Its a Bust and a base, both at angle. The bust printed fine.
The base however fails after it prints about 3 MM. I ran the tank cleaner for 30 sec and was able to peel the failed print off. The base portion is just raised enough above the cured rectangle to catch a spatulas edge.
Next print did same thing. I think Its failing about layer 10 or 20.
I am going to move the print from the build plate center toward one side and try again.
Beside this. Any thoughts?