I recently built my voron so I am kinda new to this.
I want to print a few accesories for my 3d printer and it does this. Layer shift or idk what it it called. I tightened the A,B belts and it still does this.
It makes this mistake at the same height.
Any help?
Hey everyone,
I recently finished building my Voron 2.4, and it was printing beautifully yesterday. I successfully printed two "RockNRoll" for the back, but now that I'm printing the top hat, and it's making a strange noise. I've attached the link of the video. Has anyone else experienced this, and what was the fix?
​
Hey everyone,
I’m running into a strange color syncing issue with my Neopixel setup on an A4T printer running Klipper. I have a chain of 3 LEDs.
​
The Problem:
When I set the LEDs to White, all 3 light up perfectly white and in sync.
However, if I try to change them to any other color, they don't sync up. Instead, every single LED shows a completely different color at the same time (for example, trying to set them to red results in one red, one green, one blue).
It feels like a data mapping shift where Klipper is sending RGB/RGBW data but the LEDs are expecting something else, pushing the color data down the chain incorrectly.
​
Ignore my cartographer hanging around :)
​
Thanks in advance!