u/SPHARTAN

Yesterday I experienced that when I opened the door, the window rolled down slightly as normal, but when I closed the door it did not roll back up and seal properly. When I opened the door again, the window went down a little more, and this kept happening every time I opened and closed the door until the window was rolled completely down.

I read that I should calibrate the window, so I tried holding the window switch on the driver’s side up for 30 seconds. But when I then tried holding it down for 30 seconds afterwards, the window would not roll down.

Now it seems like the window is stuck. I cannot control the window up or down, neither from the driver’s side nor from the door itself where the window will not roll down. Because of this, I also cannot open the door, since the window does not drop slightly and instead stays fully raised under the door trim.

I have restarted the car using the buttons on the steering wheel.

I have not third-party puddle light.

I cannot check whether the puddle light under the door is working, since I cannot open the door.

The issue is with the rear left window.

Is there anything I can try before calling an expensive Tesla technician?

Thanks in advance :)

Hi!

I currently have a wheelset with an HG freehub and a SRAM Apex AXS XPLR cassette (XG-1231). I’m now looking at buying a new wheelset and I’m considering getting it with an XDR freehub instead (hopefully a bit more future-proof).

Which cassette would I then be able to use, or which one would you recommend? My current setup is SRAM Apex XPLR eTap AXS with a 42T chainring, so the cassette needs to be compatible with that.

It’s the first time I’ve really looked into cassettes, so I honestly don’t have much knowledge about them yet — I’m really looking for your experience and recommendations.

Thanks a lot in advance :)

Hi!

I’m about to buy my first wheelset. I’m not a professional, but I feel like it’s time for a new set of wheels 😄

I visited my local bike shop, and they had the ELITEWHEELS Carbon Wheels ENT 2.0 and the Marvel 50D first-generation model on display. I really liked the design and actually prefer the “old” design compared to the newer Marvel II model.

The price difference between the models is around $150. Do I get more value for money by choosing the Marvel 50D, or does the ENT 2.0 have newer and better components?

What would you recommend? Thanks in advance!