I'm aware of that if it was ported it won't run great, but I'm not worried about that.🤪 Regardless of that, I was under the impression a major setback for a Dusk TP port was lack of initial OpenGL support. Does it's new inclusion mean the door is open for someone to attempt a port?
My original setup was up in a warm loft and had the card blowing inward with stock settings. GPU temps would climb to 85-90C in 10 minutes while gaming at 4K. My RAM, CPU, SSD, and motherboard were cooking. It sounded like a hair dyer with a notable buzzing coil whine, and the entire loft would be uncomfortable to sit in for more than 30 minutes.
Then I found a reverse airflow kit on etsy and had the realization that with the mod I could decouple the spine from the GPU with some spacers leaving over an inch wide gap for airflow. I just needed to reduce my CPU cooler height. I went with the Thermalright X53 full copper with a noctua fan instead of ID Cooling IS-77-XT. CPU temps on the 9800X3D are excellent and there's no turbulence with the gap on the side panel.
These tweaks in combination with undervolting the GPU and moving the setup into a perpetually cool basement has the GPU in the 65-70c range under heavy 4K gaming, rarely exceeding 70c. It's virtually silent with no turbulence, coil whine is reduced to a forgivable hum, and the basement temps never appreciably change.
This configuration effectively resolves the thermal hurdles I had when running the 5090 FE in the Fractal Terra.
Hello everyone. I was wondering if someone could test how the Twilight Princess port performs on the Miyoo Flip V2. Thanks in advance!
The dream is apparently still alive and well. I found these at a store near me and I honestly cannot believe they let go of them for that price. I might actually finish my (non mega rare/misprint) Mata mask collection now. I know it's very unorganized with many missing and too many masks to add for the slots. (Pardon the stray Nuva mask) I'll reorganize and build a mask stand soon. I've quite a few to add.