u/Solaris_fps

I made a box frame to mount my 450w solar panels to the roof of my shed. They are currently facing north is it possible to get these facing south with a tilt bracket any recommendations?

Im based in the UK and its virtually impossible to install a portasplit in my living room, windows open outwards and dont open all the way. I was using a obs board to stand the machine out so its a pain in the ass to bring it in every night requiring 2 people.

I have seen someone cut there window frame but that is not an option.

My solution was to replace the bottom window with a polycarbonate sheet. I ordered a replacement glazing unit for £60 so I have a spare window incase I ever need to reverse this setup or store over winter. I then took the pannel out and seperated the glass from the original unit using a knife. I cut a section out of the aluminum frame to allow the hose to pass through and cut the polycarbonate sheet and taped it to the frame. I then put the frame in and put the uvpvc trim back. I used some insulation that came from the portasplit as my hole wasnt exact.

I have the bracket that screws into the wall so its now mounted outside and I can shut all of my windows and let the machine run overnight.

Can you tell the difference and which do you prefer?

Two neo geos were tested each with a different RGB mod. So first three images are one rgb mod and the other three are a different rgb mod.

Finally got the portasplit installed thanks to the universal bracket. Already feeling a difference vs my bosh mono block which had an inverter.

​

Reasons for the universal bracket.

​

Was not given a window mount plus my windows go outwards and the gap is less than 50cm so I dont think I couldn't It anyways.

​

I have a small window before the opening window meaning I cant use the supplied fixed bracket for wall mounting as the pipes aren't long enough.

​

Why the universal bracket works.

​

With the universal bracket in the balcony arrangement it rests on the lower window and has no where to go. I pull down on the bracket and it is strong a secure.

Received my mida multi split from amazon. It comes with a fixed bracket which is fine but my opening window starts way to high up and the hoses aren't going to be flexible/long enough for me to mount the unit as per the manual.

What are my options here if cant use the window mount as I dont have one and my windows open the wrong way. Will the universal mount work on this scenario or is there no chance

My windows can open unlocked all the way out fully ad well.

The card has a slight tilt would this affect a chance at a 10?

Wrap us tight around the box with slight loose excess. Is this a reseal i got the 2 other boxes as well look the same