I see recommendations to use putties, usually car fillers are talked about, but I haven't ever seen a brand or particular type talked about, just very general overviews.
What would be good? Preferably something I can buy in melbourne, but internet links would also be great!
This is to fill in areas where I have glued together parts, and also areas where I can see layer lines. Mostly the glue lines, though.
Cheers
I was reading about how the many different priesthoods of rome and greece were organized, and how many were intertwined with all sorts of elected and hereditary political positions, and I have been wondering if there are any descriptions out there about germanic priesthoods and cultic practices, specifically how they are organized.
Bonus question: is there anything similar for celtic tribes conquered by the romans?
I was reading about advances in brain implants and how sending feedback into the optic nerve is gaining in resolution, and began to wonder about how the brain would be able to receive sensory data that is outside of the current setup.
I understand that the human brain is still able to control a tail, if it were there, but would radical changes (a second set of arms or eyes, for instance) be able to be parsed by an adult brain?
How the heck do I turn this off? It turns on randomly, and I cannot get it to go away. I tried editing the config file as suggested elsewhere, and it rarely works.
Anyone have any ideas?
I have been printing using the .12 layer height profile on CrealityPrint, and now that I am gaining confidence, I am wondering if it is possible to create an entirely new profile, set up for an even smaller layer height.
I realize that this would make prints take longer, but I am just curious how fine a resolution I can make with an SE.