I’ve noticed this problem happens mid print after a certain height is reached I’ve also noticed weird. I’ve got no clue as to why this is happening; anyone knows what causes this?
I’m looking for some help diagnosing a 3D print issue. My first layer starts out looking good, but there are sections where the top surface becomes rough and exposes the infill, especially around the edges. I’m printing with PLA, and I’m not sure what this is caused by as I’m relatively new to this. Has anyone experienced this before, and what settings or checks would you recommend?Thanks!
Hi guys! I’ve been trying to print a large print on my ender 3 v3 se. Upon auto leveling the z offset is set too low (-1.27) and so I used the paper method and test printed till I found an offset of -1.35 which was being used in the above print along with pla + .I’ve noticed that lines over certain parts come out differently can someone help my identify this problem and or help my fix it.
Sorry about the poor picture quality. I’m using the stock build plate that came with my Ender 3 V3 SE and Numakers PLA+ filament. I even applied a glue stick just to be safe, but this still happened. Does anyone know what might be causing this or how I can fix it? Any help would be much appreciated!
I’m trying to print a spine cable chain for my elder 3 v3 SE. the first layer is not printing well and I’m worried if I made any mistakes during slicing or if it is improper maintenance. (I stopped the print midway)