u/Strict-Height-9872

Hello everyone, I'm quite new to drone construction, I built a tinywhoop but it didn't go very well, but now I wanted to try with a 3inch (possibly sub250 but only the frame and components get to 190g😭), I know that the esc will be overkill but I wanted to take it that then maybe I pass it to a bigger drone like an axisflying ban, I also take the vtx and limit it and later I will move it to a bigger drone

I'm just asking if maybe you can tell me if they have mating problems or things like that

Guys, I need urgent help, I wanted to do a 3inch build, and I looked for the manta 30 frame (you will say that it is heavy and that there is better, but I like it), only that reading in the c204 engines of the axisflying it says that the hole is an m2, but reading on the specs of the manta frame it says that it uses m3, so guys, what the hell does it use???

Hi, I'm quite new to drone builds ( I built a tinywhoop and it didn't go well ) and this time I wanted to try something bigger , I thought of a 3 inch since I already have a 6 inch , so I looked at everything (about cheaper) and I saw these 2 stacks , one was from the 9imod and it was a cheap f722 , and then I saw this one here from the iflight, I think the one from the Iflight is better, only that I looked at the dimensions and this one of the iflight is 42x35 (The esc because I have already calculated the fc and it is smaller than the original one), only that the original redfox a3 of the sub250 is 33.5x33.5, so now the question is, will the iflight stack fit or not? I ask anyone who has the oasisfly30 if they could take 5 minutes to create a 42x35 rectangle on a sheet of paper and put it on top and send me a photo so I understand. Thank you very much anyway in advance
( I dropped my build so can you rate it?😆 it’s around 230$)