
Are some one have schematic of YF-BKT50V50A converter?
First symptom: converter not starting and eating about 110 mA of input current. Further research showed that the left LT8930 chip, the one closer to the input terminals, does not start. At the VIN input (pin 7) there is a voltage, the same as at the module input. At the intvcc output (pin 8) there is no 5 V voltage. Then I found that the circuit from pin 8 is shorted to GND, and the current of 110 mA is the internal limitation of the 5 V regulator in the LT8930 chip. I found that one more small chip is powered from this output (most likely it is an LM358) and there are ceramic capacitors near both chips, these elements were desoldered and checked, they are OK, and the short circuit remained on the board. What other parts of the circuit are powered from this output, what else should I check?