u/Technical-Present865

First day with my RFB out at the range, getting the scope zeroed and adjusting the gas.

• Scope was good, gun was accurate, and I think I need to increase the gas a bit.
• Firing 168gr PMC X-TAC

The problems however...

1. When releasing the charging handle to chamber a round, sometimes it would only go halfway and need me to push it to the end.
2. On multiple occasions (5 or more times) I would pull the trigger and nothing would happen.

---> primers were being dented but not going off. HUGE safety hazard.

3. I had one double feed, don't know why. Looked like the rounds got chewed up a bit.

4. One round went off half a second after the trigger was pulled

5. On one occasion, the RFB locked back when there were still rounds in the magazine

I didn't lubricate or clean it as it hadn't been fired prior to this. Is the issue the firing pin? The gas? The ammo? Should I send it in to Keltec and have them look at it?

Thanks for your thoughts.