▲ 1 r/Lymow_Official
Bearing grease
Assuming a put a seal over the deck bearings after application, would red n tacky be the right type of grease? I’m reading that it’s good for industrial bearings, mowers, etc. and has a high temperature threshold which I assume mower bearings will experience.
Anyone have better experience or knowledge they can share? Plan to grease and seal with 15x32x7mm seals
u/Tennorakka — 3 months ago
Landmarks
Are the auctions going to be for the entire landmark or just a single parcel of one?
For example if you won say the Empire State Building, are you getting like 100+ parcels? Or just the bragging rights and it counts as 1?
u/Tennorakka — 3 months ago
▲ 2 r/Lymow_Official
Thoughts? Thought it might be track tension, but it’s not
Even with the track completely off the rear up is creaking. Never had an issue. Just randomly started today. All screws are intact and on the hub. Not loose at all.
Any ideas why it’s creaking?
Still drives straight and has power. Just completed a mow and started creaking on the last few strips
UPDATE: checked wheel hub opening it up. Perfectly good. Zero worn teeth. Interestingly when I spun the hub freely without the 4 screws in there is no noise. Once I reset it and tightened the screws the sound came back. The photos I’ve commented that black spacer is somehow jammed into the wheel and is creating a space issue. I’m almost certain that’s the issue as the wheel sits too close to the chassis. The black ring is somehow shoved into the wheel.
u/Tennorakka — 4 months ago