u/Toddie19

Hello everyone, I finally bought a second barely used nubia z60 ultra for around 56k yen (350usd-ish), only has 42 battery cycles.

Now, the listing said z60 ultra not leading edition but when I took some pictures the watermark is z60 ultra leading edition, the box says z60 ultra only. Picture above for reference. Is it a bug like maybe when they push a major update for the leading version release? I'm just curious since the release window is different for both phones.

Thanks

Hi everyone, I'm a new 3d printer owner and I just installed klipper on my sovol sv06 and wanted to try increasing the print speed. I've done the extruder calibration and z-offset+paper test. It prints the "Scatter square patches" without problems but for some reason in this particular test the first layer point which is the bottom and top side the filament never touches the anchor frame and always leave a gap with a blob-ish end. When the second layer starts the nozzle just scrapes the first layers because of the blob. My first layer speed is 20 and infill 25 mm/s with the first layer height of 0.25mm. What can I do here?

Thanks