Wondering if anyone has a different layout proposition compared to what the builder has designed. Not really a fan of the corner shower in this case. That is my main gripe. Any suggestions would be greatly appreciated.
Thought I would leave a solution as I had been scouring Reddit for the past few days. I purchased some Bambu PA6-GF and tried to use it straight out of the package on the textured PEI plate. As you can imagine, by the 2nd or third layer all the pieces of the print popped off at almost the exact same time (default Bambu settings for this filament).
Went through Reddit and instead used the engineering plate, Elmer’s purple glue stick applied to the plate, preheated the chamber (50 Celsius during print) and increased the bed temp to 120 Celsius, and dried the filament at 70 Celsius for 10 hours (printed using the AMS).
All my parts printed perfectly after that. I will try the same setup as I am going to try using PAHT-CF tomorrow.
Hope this helps someone who may be in the same situation as me!
Picked up a green rubber strap for summer. This was my father’s watch which he has passed on to me. Who thought a matte green dial could look so good in the sun?!