u/Turn00

Is there a way to fix un-synced audio?

Using a legion tab 3, snapdragon 8 gen 3, playing tomb raider. The audio is not synced, a bit slow. I'm not sure if it's because I'm using Bluetooth headphones or not. I do have low latency mode on. Is there a way to adjust the sync in the settings at all? If there is I can't find it.

Thanks

reddit.com
u/Turn00 — 2 days ago

Has anyone gotten subnautica 2 to run on a snapdragon 8 gen 3?

If so, can you post your settings? I'm still getting either a black screen or the dx12 error.

Thanks!

reddit.com
u/Turn00 — 3 days ago

Wondering how long it usually takes to get a known config for a new game

I'm brand new to gamenative and really appreciate the import known config option, both for ease of use and for learning. I'm wondering how long it usually takes to get one for a brand new game? Running the newest build of gamenative on a legion tab gen 3 and the game is subnautica 2. I've read it's already running on winlator.

Thanks!

reddit.com
u/Turn00 — 6 days ago

Subnautica 2

Has anyone tried to get Subnautica 2 going yet? I'm new to Gamehub and can't get it going. I start it, it shows the initial load pic/game name, it goes to a black screen, but then I get the following error: Your game might not have exited correctly the last time you played. Verify your system meets the minimum requirements, and if this persists, update graphics drivers, or try resetting or lowering game settings.

I've tried a few GPU drivers, but they all end the same.

Any other hints of troubleshoots would be appreciated

reddit.com
u/Turn00 — 7 days ago

Best process to get a game to run

Just started using gamehub on my legion tab gen 3.

Wanted to play grim fandango from my steam account, but it keeps kicking me out after the games loading screen. I'm wondering if there is a doc or procedure that most people use to try to figure out which compatibility layer to use and what other settings to try to get it running.

I did just get it past the loading screen using proton11.0, but it's a little choppy.

Thanks!

reddit.com
u/Turn00 — 9 days ago
▲ 4 r/ryobi

Hoping someone can help me with this. Unfortunately, mice got into my mower this winter and chewed up some wires. If you look through the red circled area, you can see them in the second picture. If I remove the 4 yellow screws, the blue outlined part comes free, but the bottom section of that part is wrapped behind the rear wheel drive shaft. If I could get that off, I think I could access the wires and splice them. Has anyone had experience removing that blue outlined section?

Thanks

u/Turn00 — 19 days ago