Bed adhering problems
My prints are not adhering to the bed in some zones. Any help?
u/Vulcan0015 — 11 hours ago
Issues with First Layers
Hello, why my first layer looks like this? I have calibrated the printer, it prints better after the calibration but the first layer does not look good anymore. Any help greatly appreciated.
u/Vulcan0015 — 1 month ago
Surfaces does not look right, show holes or the surfaces finishes wrong
Hello, my flat surfaces are finishing like this, the printer has its enclosure to keep an even temperature. Any help with this issue will be greatly appreciated.
Brand: Anycubic
Model: Kobra 3 Combo
Nozzle Temp: 220 C
Bed Temp: 60 C
First Layer Speed: 50mms
Outer wall: 60 mms
Inner wall: 150 mms
Sparse infill: 180 mms
Filament: Winkle PLA HD White
Thank you
u/Vulcan0015 — 2 months ago
Why is this happening to my prints first layers?
Hello, recently after my printer start doing this when doing the first layers, the rest of the print ends fine (most of it) but this issue is showing recently.
Brand: Anycubic
Model: Kobra 3 Combo
Nozzle Temp: 220 C
Bed Temp: 60 C
First Layer Speed: 50mms
Outer wall: 60 mms
Inner wall: 150 mms
Sparse infill: 180 mms
Filament: Winkle PLA HD White
u/Vulcan0015 — 2 months ago