u/Working_Cellist_5412

I am trying to print a very tall and thin object. I went with 0.08 layers and speeds of around 30, 10 for the outer walls.

Should i design some kind of support to stop it from wobling on the higher levels?

Printing at an angle or on the side makes the legs impossible to detach from the supports because of how thin they are.

How would you print this?

Ender 3 v3 SE

Resin plate

AzzureFilm PLA

205°C/60°C

0.08mm

I did a project for my friends nephew and since it was my first project for someone else I wanted to make sure it's perfect. I think I got pretty close to that

Models by:

Bokkins3D - garage and lifts

Petroslav04 - cabinets and shelfs

Both on makerworld

I am getting some weird separation in the middle of my prints. Does any one know the solution?

Ender 3 V3 SE

Azzure film PLA

0.16 layers

2 walls

I don't know what other settings could be relevant

Please ignore the glue drip 🙈

I did every calibration available to be able to print this 😅

Now i need multicolor 🤭