My group head rinse is set to 8 seconds but it really only runs for about 3-4 seconds. It’s nothing super concerning since I can just run it twice. If I reboot the machine then it will run for 8, but then after I pull my shot it goes back to about 3-4 seconds. Is this just a firmware bug?
Here’s my situation
Was on the SAVE plan. AGI was like 46k. My monthly payment was 0. I’m at 105 qualifying payments but under those couple years of forbearance I’m at 120. My account reads 126 payments. But I just got my employer cert and applied for buyback. I owe about $2,900 in loans. (I found out about pslf super late and had already paid about 60k off) so I applied just because I could to get this last 3k ish forgiven. Basically I was all good to go and cruising til all this stuff hit the fan. Now I’m just trying to figure out what to do next. Do I just wait for buyback? Or just pay the rest off? Or what. I’m not sure how to do the math on all this
Anyways if anyone has any suggestions let me know
When I turn on my machine, during the first 3 minutes or so of the warmup phase, I get small, slow dripping (nothing crazy) from underneath. After that it stops completely and it won’t drip again until tomorrow morning when I turn it on again. Is this normal or is there a fix?
When I finish making espresso my pressure gauge creeps up to about 8 bars while stagnant. It dissipates after I drain the steam wand and flush the group head for about 3 seconds. Is that normal? For the machine to hold pressure like that after I’m done? Only a week into my machine so I’m still learning