I *vibe coded* to make my 3d printing jobs easier. This can render 3d files inside trilium. You can also measure two points. It literally runs threejs as a backend and it is implemented as a widget. If you guys are interested I can share how it works.
Here is the github repo to make it run on your end. Instructions are in the readme file.
I had to return back bc of the battery but that'll be fixed soon!
Body: ZOHD Dart 250
Motor: 1408 4000kv
Prop: 5x4 2 prop
ESC: 40A blheli esc
FC: Speedybee wing mini
Receiver:900 mhz ELRS, Happy model I think
VTX: TBS Fusion something, 2W
Battery: 2s Molicel 18650's. 3500 mAh
GPS: HGLRC M100 Pro, 43 Sats is wild ngl
My U1 will be delivered this week or the next. So I'm already looking for mods that people are doing. I already saw the enclosures but what are other useful mods, software/electronic/hardware, doesn't matter can you guys suggest? Lets make a list on here as well so it'll be a good guide for the new people getting this printer. I already own couple printers so I'll start printing the mods etc right away
Had a little long range test with the Zohd Dart 250. I'm running TBS Fusion nano at 500mw with 2.4ghz ELRS system on Speedybee wing mini. I'm not using the original 1406 2600kv motor instead I went for 1408 4000kv motor and 5x4 prop. I'm running the whole system at 2S with 3000 mAh lion cells. My receiving side on the 5.8ghz was just one simple patch and another lollipop antenna. Bc of the position of the antenna on board the plane I had lots of issues while returning back. Rn the plane weights around 290gr fully loaded. I want to lower it more to at least 250 so I can put another cell to the battery or switch to 21700 5000 mAh cells. Over all it was a fun test. I should really finish my ground station and set a proper antenna setup