u/aliyyanimates

so im printing some gridfinity baseplates and ive noticed that one corner is taller then the others and after measuring with a calipers one corner is 8mm~ whilst the others are 6 mms. I suspected warping but the bottom layer isnt pealing from the build plate so it must be something else. Anyone got any ideas?

Im using esun pla plus with orca slicer and a stock ender 5 plus.

I printed at 215celcius , 7 mm retraction at 60mm/s , print speed is 60mm/s,with combing on

im fairly new to 3d printing and recently these really thin white strings started appearing on my 3d prints(I’ve attached image).

Im using esun pla plus with orca slicer and a stock ender 5 plus. at 60mm/s

here is what ive tried

-increasing retraction

-zhop

-increasing travel speed

-drying my filaments for 6-8 hours

-tested different temperatures form 190-230

-used another roll of filament

Im worried its something wrong with my printer or it might just be tue filamen. any help is appreciated

im fairly new to 3d printing and recently these really thin white strings started appearing on my 3d prints(I’ve attached image).

Im using esun pla plus with orca slicer and a stock ender 5 plus.

here is what ive tried

-increasing retraction

-zhop

-increasing travel speed

-drying my filaments for 6-8 hours

-tested different temperatures form 190-230

-used another roll of filament

Im worried its something wrong with my printer or it might just be tue filamen. any help is appreciated