u/andersgeorgsson

I've seen a number of YouTube videos where the creator have a logo that they add to a lid of a box etc.. Theirs seems to come through as "parts" but when I try to import the American flag from Wikipedia - it simply comes over as a single block!? If I open that .SVG in InkScape - It looks fine.. See example below - first Inkscape and then in OrcaSlicer.

Inkscape

OrcaSlicer

The edit window show it has subcomponents:

edit window

What am I doing wrong!?

Any and all help is appreciated :) I am trying to make coasters with American flag on them 😉

https://preview.redd.it/2hdxks3o6u9h1.png?width=562&format=png&auto=webp&s=a259d34218c5dc9a946283f9a6c01cfe79ca94eb

Does anyone know what these two highlighted values represents in "Flash Studio"?

I've been having this odd behavior (and i've tried unlinking printer, uninstalling the Studio software and finally deleting "remainder" folders that doesn't get deleted by the uninstaller) and then reinstalling the software and reconnecting the printer BUT issue remains...

When I close the application and reopen it - the printer ALWAYS shows as offline!
Similarly - if I turn the printer off while the software is open - then turn it on - the software never shows it as being online/idle!?

The only solution I've found - is to "unlink" the printer and add it back on when it is online.

I am running the latest firmware 1.9.3 on the printer and the latest Flash Studio from the website.

Any suggestions? I'm bringing home a new laptop to test and see if there's something special going on with my desktop that I normally use...

I just went to go place my order and now it shows as sold out 😵‍💫

https://preview.redd.it/fia3of2j936h1.png?width=503&format=png&auto=webp&s=4a3c7f0f6ba5747b419e7dd9ffb9f6f271f27375

Here I was - hoping enough people had cancelled that i'd get mine "yesterday", LOL.

"Creator 5" still showing as available as "Pre-order"

Other than the "Flash Studio Desktop" for Windows, is there any other slicers that supports this great printer? ( I haven't pulled the trigger on ordering mine yet but I'm curious )