u/bobsagetsJD

I'm having a problem using a router in AP Mode. My setup is this:

Modem --> Netgear Nighthawk RS150 (Router) --> switch --> Netgear Nighthawk AX5400 (AP Mode)

I reset the AX5400 and set it to AP Mode. When it went to restart, I no longer can enter the admin page. I have tried routerlogin.net, aplogin, I have pulled the IP from my main network page. Tried that. Nothing worked, whenever I enter any of the above, the browser just says it can't connect. The effect is I can't change the AP router's network info to have one seemless network ID/password, kind of rendering the AP mode pointless for me.

EDIT: I should note, I have retrieved the IP from the main network a few times and have noticed it has changed once or twice.

What in the world can I do to access the admin page for the AP?

Thank you guys for any help!

This is very random. I have a well that my pump is pulling water from. I live in Florida, so occasionally, I have to refill my pool about an inch because of evaporation and I do so by connecting to the spigot on the top of my pump. As of now, the only way to use my pump is to also run my irrigation cycle. I have an OLD Rainbird ESP-8 and the screen is broken. I am currently replacing the controller with an ARC8. I was wondering, is there a way for me to set this up so that I can run the pump without activating an irrigation zone? I really appreciate all the help.

I was changing out my suspension rods today when I found out the water faucet outlets to my washer are messed up. Turned the hot water outlet off, unscrewed the hose from the machine, everything fine. THOUGHT I turned the cold water faucet off, go to unscrew from the machine, and water went everywhere on the back of the machine. Didn't think anything of it other than annoying. Replace the suspension rods fine. Go to start and absolutely nothing happens.

I will say, when I plug it into the wall, shortly after there is a "click" followed by a few seconds and then another "click". No power, can't start a cycle, can't run diagnostic mode. Did I fry the control board?

Thank you for any help.