u/bublik_drdrdr

K1C, PLA, 210°, Orca slicer, KAMPP, calibrated before print

My printer bed leveling doesn't match reality, the corners are detected way too warped up and during the print the bed is lowered at those areas causing gaps between lines (I can see the Z axis rotating when print head goes to the back of the printer). It was on original firmware and using KAMP, doesn't matter if I preheat the bed even for 10 minutes before print, always the same spots are underextruded. Btw: there are "profiles" in tune tab in fluidd, bue they don't do anything, before every print it does calibration.

This exact test print: K1C, fluidd/kamp, orca slicer, petg 227deg, bed textured 80 deg)