u/coon_man_

I know this is a Florida fishing page but my wife and friend pulled tags for alligators in lake county to harvest. I’m the one with the gear and the boat. If anyone has any tips on local spots where big gators like to hang out (excluding the obvious big lakes) or would give access to private bodies of water please let me know! Very respectful folks just looking to fill the freezer, will share if tips lead to a successful hunt. not looking for anyone’s personal opinion on how the FWC chooses to manage the population. Thanks yall

I know this is a whole state page but my wife and friend pulled tags for alligators in lake county to harvest. I’m the one with the gear and the boat. If anyone has any tips on local spots where big gators like to hang out (excluding the obvious big lakes) or would give access to private bodies of water please let me know! Very respectful folks just looking to fill the freezer, will share if tips lead to a successful hunt. not looking for anyone’s personal opinion on how the FWC chooses to manage the population. Thanks yall

My wife and friend pulled tags for alligators in lake county to harvest. If anyone has any tips on local spots where big gators like to hang out (excluding the obvious big lakes) or would give access to private bodies of water please let me know! Very respectful folks just looking to fill the freezer, not looking for anyone’s personal opinion on how to FWC chooses to manage the population. Thanks yall

Removing some accessories for the Jon boat and there are 5 roughly 3/8” size holes spread out over a few inches of each other, 2 in the gunnel and 3 just below it. I’m going to use a spray foam as backer so it doesn’t fall through but would jb marine or 3m 5200 be a better application over the foam to seal everything up then sand and paint? I used osi quad max low expansion foam in the holes and going to trim it back once it hardens

Removing some accessories for the Jon boat and there are 5 roughly 3/8” size holes spread out over a few inches of each other, 2 in the gunnel and 3 just below it. I’m going to use a spray foam as backer so it doesn’t fall through but would jb marine or 3m 5200 be a better application over the foam to seal everything up? I used osi quad max low expansion foam in the holes and going to trim it back once it hardens