u/dac0586

It is a 2024 Club Car Villager 4 gas model. I have some LED light strips on the cart currently. Going to add a sound bar and that is it. Currently the LEDs are connected directly to the battery and I am sure the Bluetooth controller is probably pulling some sort of low power constantly.

My question is, I assume this would be the same as adding a fuse block to a car?

I would take 10 gauge wire, make two short runs and from the negative and positive on the battery go to the negative and positive on the fuse block. From there take the negative on the led lights/sound bar and connect directly into the negative on the fuse block, positive from each accessory would plug directly into a rocker switch for each device, make my own power cables from the rocker switch to the fuse block and would I need to make a negative run from each rocker switch to the fuse block? Or having each accessory negative go directly to the fuse block correct?

My wife and I were lucky enough to get a dock this summer at our small local marina through their lottery drawing. Prior we would of course always pull the boat out after a day on our small lake, clean the boat as necessary and then put the cover on it which has 3 support poles.

With the boat staying in the water this summer any recommendations for a cover that is easier for me to put on after each use? I was thinking of just covering the seats and the console.

It’s a 2018 18 foot sun tracker boat party barge dlx.