u/higunner00

I finally got Klipper working correctly yesterday and I printed a cube to check for speed and stuff but I am finding two issues. One is that the corners look 'pinched' for lack of a better term and secondly the last layer seems like it has peeled off. The former is a new issue that I am attributing to not having calibrated properly but the later I had issues with the original marlin. What am I doing wrong? It's an Ender 3 with an SKR mini 3 V3 board and Klipper

Asking for help. I just installed Klipper on my ender 3 with a SKR mini e3 v3. I am using an old laptop (Lenovo Ideapad S300), i ran a bunch of tests, I managed to run the bed mesh, home, etc, even managed to print a Benchy, however when I tried to run some of the calibrations of OrcaSlicer, it started stopping after a couple minutes and showing 'MCU 'mcu' shutdown: Timer too close' . I have tried different Gcode files, even the same Benchy I already printed and always does the same. I have replaced the usb cable twice and the laptop is plugged in via Ethernet cable. I am honestly running out of ideas. The laptop is using Linux Mint and Mainsail for the interface. What could I do to solve this issue?

Hello, I just installed the Mini e3 v3 on my old Ender 3 v1, and everything was working as usual until I tried to use the CR Touch to try and level the bed. It homes to X and Y alright but when it comes to using the probe, it does check but instead of giving me the Z=0, it shows Z=830+. The same issue appears for both the BL Touch firmwares on the BigTreeTech github. I have tried with and without the Z Limit Switch. What can I do?

https://reddit.com/link/1t2ee5a/video/6vmthas0hvyg1/player

Hello, I just installed the Mini e3 v3 on my old Ender 3 v1, and everything was working as usual until I tried to use the CR Touch to try and level the bed. It homes to X and Y alright but when it comes to using the probe, it does check but instead of giving me the Z=0, it shows Z=830+. The same issue appears for both the BL Touch firmwares on the BigTreeTech github. I have tried with and without the Z Limit Switch. What can I do?

https://reddit.com/link/1t2ebif/video/66txhxc1gvyg1/player