2016 scrambler 800 won’t start. Diagnosis listed below
u/jackthebat99 — 3 days ago
▲ 9 r/Aprilia
Best option for rear seat cowls?
I’m sure this has been covered before, but I currently have an amotopart cowl on my 26’ Tuono and it sucks. The fitment is trash and it’s already broken. Has anyone had luck with the OEM variant or the other amotopart version (in second photo)
Thanks!
u/jackthebat99 — 11 days ago
▲ 57 r/Aprilia
Rode 700 miles of twisties down at the TOTD: Great way to break in the baby Tuono and my shins ⛈️
u/jackthebat99 — 17 days ago
▲ 164 r/Aprilia
First Italian bike after 7 years of riding
This bike is so gyattdayum fun. My other ride is an MT-10SP. Would anyone say spending $900 for an additional 2 year factory warranty is worth it?
u/jackthebat99 — 27 days ago
2016 not running, not getting fuel.
It’ll run on starting fluid, it gets no fuel delivery.
I took the injectors out and primed them with a 9V battery, I got them clicking and spraying.
The bike will run briefly if I prime the injectors and die after 1-2 seconds.
For some reason, it’s not delivering fuel.
My suspicion is not that the injectors are bad and everything before them is working. Fuel pump primes, fuel rail is pressurized. I’m at a loss.
Also, I noticed that when the fuel pump primes and I look inside the tank, I see fuel spraying around quite a bit. Is this normal so the rail doesn’t over pressurize?
ANY help would be much appreciated thank you.
u/jackthebat99 — 1 month ago
▲ 8 r/bmwmotorrad
2001 R1150GS clutch rattle noise
To those very experienced, does this sound more like input shaft wear or a worn out pressure plate pushrod sheath? The bike runs fine, shifts fine, no clutch slip, doesn’t make the noise when in gear, and doesn’t make the noise when in neutral and clutch is pulled in, which all leads me to suspect it’s free play in the pushrod and thus just mechanical noise and nothing to worry about. It only makes the noise when given initial revs and when at very low rpm when warming up.
This GS has 54,000 mi and had a new clutch and slave cylinder put in at around 53,000 mi.
I have not pulled the starter motor yet to inspect input shaft wear.
u/jackthebat99 — 1 month ago