u/jkingdon1

Hi, first time post just looking for some advice. I'm planning on starting the interior transformation of my Z. First thing is to take the headliner out and get this print on it. My plan is to do the following:

1: Remove headliner, scrub with brush until all the old foam/adhesive is removed, clean with panel wipe

2: Spray Trim Fix heavy duty high temp strong adhesive on the headliner & back of my foam backed headliner padding fabric, leave to cure

3: Spray Wayside HTA1000 Waterbased (Heat activated) contact adhesive on the foam, using 1.4 tip HVLP gun, then spray the back of my 140gsm cotton foil print fabric

4: Drop the fabric on to the foam with a helper to keep it stretched out, activate with a heat gun and then trim to size

5: refit and hope for the best 😂

Not sure if anyone else has tried this sort of thing before? Im most worried about bleed through of the adhesive on the cotton. Considering only spraying a fine layer to the foam, bringing the cotton to it before it flashes off and heat activating it after?

Thanks for any tips!

Recently got into making liveries. I get so far with them and then completely hit a wall. I feel like filling the side space is fairly easy but then trying to connect across the roof or front/rear I get stuck.

Any pointers? Tia

I have the usual rust on my rear arches, unfortunately has gone a little too far to repair with some simple welding.

Looking to install some fibreglass overfenders and run some wider wheels, however struggling to find any recommendations in the UK.

Only looking for 15/20mm, but needs to be good fitment and would prefer to see some examples of them installed. Lmk if you can help me, tia!