.2mm printing not adhering to plate
I’m new to 3d printing but I’ve had a decent amount of success with the .4mm nozzle in my A1 using PLA Matte filament, doing a lot of one click prints and a few things I’ve adapted myself on bambu studio. I’ve changed the nozzle to a .2mm, cleaned the plate, used the new untouched side, set the prints up in bambu studio using the 0.06 high quality @ BBL A1 0.2mm nozzle setting, that has 16mm/s initial layer speed, 28mm/s initial layer infill speed and has auto support trees but I’ve had to abandon two prints in two days as it releases from the print bed and/or becomes a stringy mess; am I doing something obviously wrong? Or is there something I can do to solve the problem? I’m trying to get some high quality terrain pieces sorted and the print times are three to four days, I’m worried I’m going to keep finding in a trashed state. (I did another lot yesterday, which I didn’t take pictures of; different prints, all released and flopped around the plate) - any help would be appreciated!