u/m65r

Hello everyone,

Did some digging but couldn’t find an answer.

Is it possible to have throttle/dual rates setup on a switch?

Looking to have a throttle limiter on a switch.

Cheers!

Hey peeps!

Looking at building a MB18 from scratch and I was wondering what people have done 2 speed box wise.

I’ve considered the meus transmission but think it’s heavier than I’d like (or at least higher cg)

Does anyone have experience with the MB18 kit and the RCAwd 2 speed kit? Unsure if it’ll fit in the cage.

Also considering the Traxxas 2speed but concerned about the plastic gears (has anyone used a generic servo setup for this? Rather than the Traxxes shift servo.

For those against the two speed, I’d like to build a basher / crawler (u4 inspired). Any suggestions for drivetrain if going single speed? I did consider maybe something along the lines of 3500-4000kv brushless with around the 15:1 ratio mark but unsure if it’ll be quick enough (would like to jump it and do dumb things with it) but still have decent slow craw control.

Would probably still go around the 3500kv range for the two speed setups.

Hey peeps!

Looking at building a MB18 from scratch and I was wondering what people have done 2 speed box wise.

I’ve considered the meus transmission but think it’s heavier than I’d like (or at least higher cg)

Does anyone have experience with the MB18 kit and the RCAwd 2 speed kit? Unsure if it’ll fit in the cage.

Also considering the Traxxas 2speed but concerned about the plastic gears (has anyone used a generic servo setup for this? Rather than the Traxxes shift servo.

For those against the two speed, I’d like to build a basher / crawler (u4 inspired). Any suggestions for drivetrain if going single speed? I did consider maybe something along the lines of 3500-4000kv brushless with around the 15:1 ratio mark but unsure if it’ll be quick enough (would like to jump it and do dumb things with it) but still have decent slow craw control.

Would probably still go around the 3500kv range for the two speed setups.