u/microbioboy

Just installed the Alba and finished my custom Acacia integrated drip tray!

Good intro to Brad nailing and making miter cuts. Definitely a bit rough but should serve pretty well! Top frame is flush on one side to accommodate being hung from a balcony. Bottom is pressure treated pine and the rest is made of cedar slats. Definitely need to invest in some corner clamps!

Just finished a way cleaner display set up after accidentally knocking the old display off and breaking it. Followed this post on the r/gaggiaclassic page:

https://www.reddit.com/r/gaggiaclassic/comments/1rof9n3/stepbystep_guide_to_upgrade_your_gaggimate_with_a/#lightbox

Uses the LilyGo 1.75 screen and a housing I 3D printed. Here is the link for the housing file:

https://www.printables.com/model/1491049-different-housings-for-gaggimate-lilygo-s3-amoled

Use version 3!

Needed a new way to hold up this beast!
Definitely not perfect, but had to finish it at some-point. Started as a poplar board, stained with a cognac oil-based stain and yes, sanding was a nightmare.