I bought elite and am confused where the after show videos are. I wanted to see Mondays episode, “the most ghetto financial audit ever,” after-show. When I search the members only area on YouTube, I get several other videos with the same name but not the one I’m looking for. Does he just take a while to post them ? I’m only 30 but feel 80 right now lol.
The sound from this speaker keeps going in and out on bumps. And when it comes on, sometimes it’s at 75%, sometimes 50% loudness, but never full loudness. I tried redoing the spade connectors, redoing the connector that goes to the factory wire. Nothing works.
Drove to Delaware and was on local roads for a few hundred miles so not just the NJT and I95. I felt like every road was so smooth the entire time. Why is it that our roads are a bumpy and never get paved ?
Also, until I got within 50 miles of NYC , I didn’t see one of those tandem speed racer guys where there’s a BMW with ugly rims and a spoiler racing against his friend in either a Porsche cayenne or Toyota Camry that has some plastic trim kit.
I’m getting near the end of my install and don’t know the best place to mount my fuse. I want it to be as close as possible so I was thinking between two locations but let me know if this doesn’t seem alright please. also I only have the amount of cable left as slack that you see in the picture running along the top.
1 - (first pic) on the battery metal holding bar. this is my first pick bc it’s close and doesn’t need to bend a lot but it’s under the air intake and only had a little clearance. so to take it off I need to remove the intake plastic and the front engine compartment cover. not super annoying but I also don’t know if there’s enough air flow.
2 - on the rain guard sill(not sure name). a bit over 12” so not sure about this.
3 - on the engine cover plastic. this would be very easy but would need to remove those screws each time I accessed engine.
4 - open to ideas.
also, can I keep my power cable on the rain sill thing if I zip tie it down and use permatex silicon on the screw holes? may need to elevate it so water doesn’t pool on the wire.