u/thatguytt

Printed using 80% PLA, 20% LWPLA.

https://www.thingiverse.com/thing:3685622

I included a 20g servo and custom rudder/servo mount using the rudder model provided.

HOTRC DS-600 6CH 2.4GHz RC Transmitter and Receiver Remote Controller with DS 600 PWM 6 Channel Receiver for RC Boat (w/PWM RX)

GOUPRC S3650 4300KV Brushless Motor 3.175mm Shaft with Upgrade 60A ESC Electric Speed Controller Combo Set for 1/10 RC Car Buggy Off-Road Monster Truck

MECCANIXITY Drive Shaft W Propeller Universal Joint, L250mm Shaft L200mm Sleeve D36mm Stainless Steel Propeller 3-Bladed Paddle Fit for 3.17mm Motor Shaft RC Boat Coupler Assemble Kit

Polycarbonate windows, clear gorilla mounting tape, e6000 glue, 2” clear packaging tape, lead weights for ballast, spray paint, and foamboard should round out the build. I did spray the exterior of the hull with clear flex seal before applying the final layer of paint but probably not a need.

This took about a month of printing, assembling, and painting. Running a brushless direct drive on 2s is wayyy faster than I assumed it would be so I added about a little more ballast using lead weights.

I’ve had an ender 3 pro for 7 years that I’ve updated over time and have no issues with. I bought this printer off marketplace for $25(figured I’d use it for spare parts). It came in parts and I learned during assembly the screen was broken. Bought a new screen and figured I would try a sprite direct drive. It came with the BL touch so I figured why not and threw it on too.

It seems that even though I am saving the settings after re-configuring that it is resetting just a little(1mm) too high after rehoming. I have tried adjusting the z offset but it doesn’t seem to fix it. It also seems to have under extrusion issues… I’m using creality print and have the printer setting as an ender 3v2.

Can someone help me figure these issues out? More than happy to share more info as needed! Thanks in advance :)