u/waynetogo

Monthly usage is over 2,000kWh. Average 2,300kWh with the high and low months, every month is over 2k.

I’ve been searching powertochoose for a bit before the earliest signup date and saw this rate. 12.3cents per kWh for 2,000kWh. Early termination fee of $150. I signed up for it.

Since then, I seen it dropped to about 12cents through 12.1cents for the same plan, then it suddenly vanished. I’m looking at similar 36 month plans and there were some comparable to it but the early termination fee was over $300.

I think I did pretty good, with the low early termination fee so if rate drops significantly, it’ll be easier to change plans without having the rate need to drop too much to the ETF worth it. I have it planned to start shopping around April for my plans, which is usually the lowest rate next to September/October.

I think I scored on this rate, especially at 36 months fix rate non time of usage. This is in the Houston market.

https://imgur.com/a/i0GwIRH

Mint tube of 2022 Canadian silver maples (25 coins in the tube)

Taken out from a fresh monster box

$2035 shipped via USPS ground advantage with tracking, signature optional without charge if you like. Let me know when you send me your address after payment.

I will keep you updated with pictures and status, but once package has been dropped off and accepted by the usps counter person with receipt, not responsible for lost/damage/stolen.

Zelle

I purchased these from Steele back in 2022. When I first received them, they had debris in the tubes and had to be sent back for RMA. https://www.reddit.com/r/NightVision/comments/tzm1ov/receive\_my\_pvs14\_found\_an\_artifact\_when\_looking/ original debris.

They been stored in the case and barely used, about 1 hour of usage since then looking at stars and meteor showers. I just noticed some more debris in the tube. There are a few small ones but the one I highlighted is the larger piece.

I contact Steele and their email response from their techs said it looks like debris and it needs to be serviced yearly to prevent this. They are going to send me an invoice. Over a week and still no response about invoice or how to fix the issue.

Is it common for PVS-14s to develop debris inside the tubes and require yearly service?

Kinda disappointed it wasn’t completely fixed during the first RMA with the debris issue that more developed overtime inside since it’s supposed to be sealed. Is this a diy simple fix or needs to be sent in to address? Anyone else having debris issue with Steele made pvs-14s or other manufacturers?