Hello!
I’m new to Bambu and noticed a setting for a filter. When turned on, it says it may increase heat and will use fans to cool down. What filter is this and when do you turn it on vs not? I’ve only printed pla so far, but looking to do some asa and AB’s prints with a vent to the window.
Please advise
Is the ace pro 2 waterproof without the little rubber gasket around the lens or no? It doesn’t seem to really do anything and comes off with every lens change, so I’m wondering how important it is. Also, if it is important. How do you know if it’s installed correctly?
Hello!
I’m new to the Leatherman arc and I’m confused with the bottle opener. According to their website, the bottle opener is part of the small bit driver? Anyone know how to use it- seems like the can opener would do the trick-maybe, but their website says it’s the bit driver ?!?
Just an couple quick questions around waterproofing. Is it waterproof regardless of what mic cap is being used? Are using other lenses waterproof- such as the cinematic lens? I also took my original lens off to check that out, and some of the paint scraped off on the inside of the original lens- is that normal or a defect?