Transitioning from Nord for reasons, testing out Proton and not getting even close what I can through previous supplier.
Is anybody getting their non-VPN speeds? Had barely any drop in the past and would be able to do 1.5Gbps and sometimes more and now with different protocols not even 200Mbps on the DL. Upstream somehow can saturate.
Pulled the trigger after reading all the positives of Proton but not very happy with the start.
Installed new monitor and 16+2 CTs and initially hardwired connection and setup was without issues. Then I realized that it was supposed to be on a different VLAN and here the issues started coming.
First, during initial setup it did not prompt me to connect to WiFi (no antenna attached either).
My VLAN has no device isolation on it so I don't understand what is the problem.
Turned the breaker off for a few minutes, disconnected LAN, made sure it is set up correctly from Network side. Removed device from account prior and when trying to set up a new device it keeps asking for that damn WiFi. I do not want this on a WiFi network.
Removing the device from my account does not reset the config and all the breakers are what I named them before...
Did a clear data now, going to shut the breaker off again and will see if it will grab an IP address or I have to keep fighting it.
Simple toggle? TURN OFF WIFI?
How to FACTORY RESET this thing, settings in the app won't do much, goes through same process and auto connects to WiFi. Do I need to return the device and request a new one so it is fresh?