Please help me settle an argument. I am trying to ask the question as neutral as possible to not influence you answers. I am very firmly on one side and I want to know what you all think.
Ive seen these rigged flex risers in prefab sizes but how is it attached to the couplings? Heat? Glue?
Client came to us because the potted plants were draining onto deck causing spots and moss. Pots have pans underneath which is overflowing. They tried to decrease the water and the plants didnt like it. They had 1/4" built in 1/2gph emitter loops, so like 7 per pot, I put in a 1/2 gallon emitter to T to 1/4" line that goes right to plants. They used to run the loops for 1 min every day, i turned them on for 10 twice a week which actually decreases the overall amount of water but it wasn't enough, turned it up to 4 times a week, plants are happy but now water is spilling onto deck again. My thought was to try and drill holes in the drain pans and like glue in a little poly line so that the water drains past the wood before just going into the ground underneath the deck. Am I missing something obvious? If this description sucks I can post again with photos.
My premium episode is only 10 min but the free one is almost 2 hours, anyone else?
Considering adding IPA to my regiment. My ribs hurt from this swell. Don't tell me to improve my back muscles and truck lift, that's a big pharma conspiracy.
Pressure is fine, of the 60 I just installed 5 are flowing like this