Login

r/SimsonnRacing

Simsonn Manager or Hardware issue?
▲ 5 r/SimsonnRacing

Simsonn Manager or Hardware issue?

Went to race today and noticed in game my Brake pedal was holding at 50%. So check the pedal software its showing 50% and will not move. I cant calibrate them. I've tried different software versions, rebooting, using a different port, all with no luck. IM thinking the module went bad that everything plugs into since it also shows the clutch (which I don't have) is at 50% also. Anyone experience this? And yes I've started a support ticket with Simsonn.

FIXED I did a manual install\update of the firmware and that seems to have fixed it.

u/Historical-Ad9482 — 8 days ago
▲ 4 r/SimsonnRacing

Pro X Ultra Setup

So I purchased the Pro X Ultra throttle and brake pedal with the spring kit a few days ago and it’s currently in transit. I understand there is a fair amount of adjustments that have to be made to dial them in. The main sim I will be using them on is Le Mans Ultimate. Any tips and/or recommendations when it comes to initial setup especially for the spring kit?

reddit.com
u/TheOne8697 — 9 days ago
▲ 2 r/SimsonnRacing

Simsonn pedals not working!

Stopped working all of a sudden (haven’t played in a month or so). App manger says I need to update firmware but when I try I just hangs and says error. My control box doesn’t have a ‘flash’ button. Either way I can’t upgrade or get the pedals to be recognized by my computer/forza. Please help.

reddit.com
u/30reddits — 10 days ago
▲ 2 r/SimsonnRacing+1 crossposts

Question for Simsonn Plus X pedal owners

Could anyone with the simsonn plus x pedals please let me know what connector the clutch pedal uses to connect to the pedal box please?

I’m currently using simjack UT pedals and wanna buy a clutch for it, but the only available one is the simsonn plus x clutch
So i’m just trying to figure out if the connector is the same so i could get the plus x

reddit.com
u/lex3015 — 10 days ago
▲ 2 r/SimsonnRacing

SimHub can't searching my VAM motor

I have just received and set up my VAM Pro, VAM Neo, and VAM2 set.

In Simsonn Manager, both the pedals and haptics are recognized normally, and everything works and tests without any issues.

However, SimHub is unable to detect the devices, as shown in the attached photo.

I have already tried the following troubleshooting steps:

  1. Switched USB ports

  2. Connected directly to the PC (no USB hub)

  3. Unplugged and re-plugged the power

  4. Completely closed Simsonn Manager

  5. Rebooted the PC

  6. Updated SimHub

Despite trying all of these, SimHub still fails to recognize the VAM motors.

Could you please help me resolve this issue?

Thank you!

u/HosuHo — 13 days ago