u/546875674c6966650d0a

Installed a new doorbell today and Otis got top billing on the screen :)

I installed a G6 pro earlier, and it’s been running now plugged in for a couple hours. It is very very warm. Some might say hot to the touch around the sides.

Is this normal?

I believe I currently have it plugged into a POE++ port, as that was the easiest one to get to. Could that have anything to do with it?

EDIT: Solved - it's a heater actually running upon bootup to ... do things, and dry it out (?) and stuff... but should turn off after a few hours. I plugged it in earlier today and went out and did some errands and came back to the warmth hearth on the wall :) should be fine in a few more hours and I'll go confirm.

Installed the first G6 Pro today on the house. I had a Cat6 pulled through the wall when we had the siding redone, and another over by the other door for a 2nd install. Screwed the back plate to the wall, connected and installed the G6 on the plate. However, I forgot to pull the other end of the wire out of the attic down to where the Dream Wall is :/ so that's a tomorrow thing, and then it'll fire up!

Our 2020 Solitude 382WB lost the glossy surface in one area within a few weeks it seems. This is not an area where water runs over the surface on the dull side but not the other. No chemicals have been sprayed or applied to it. Has anyone else seen anything like this?

I haven't tried to wax it or anything yet, but wondering if that would even help here...

Hey all. Trying to cut down the pole that holds up the temporary table in our Tiffin Wayfarer. When we had a pole like this before, the rubber caps on the end just popped off. I planned on trying to do that before doing any cutting but... we went shopping today and my MIL and BIL decided to 'help. So now I have a cut pole and, they found out AFTER that the rubber end caps are glued on to this one.

Is there anywhere I can get one of these online so that I can glue a new one onto the new cut end? Dealer is of no use (shock, awe), and Redbay isn't able to help either.

EDIT: Support helped me track it down!

https://itcshopnow.com/products/surfit%E2%84%A2-replacement-table-leg-end-cap

Having a weird issue with my wife's ENO Doublenest. There is a light stripe running through the middle, which looks like some of the UV bleaching my other one has gotten in some spots - but never there. And there is this 'oil' looking stain that just showed up. It's been wrapped up in it's bag for the past 4 weeks since we had it out in OBX and it didn't have anything on it or any spot at that time when I packed it up. Any idea?

Can you wash these things? I've never actually needed to find out :/ We have others so I'm not too bummed about it but this one is her favorite color.

*raises a glass*

Why does no company actually use this design as the base for an RV? Kitchen and living room upfront, bathroom and office and bedroom in the back? Looks like ample room for a nice floor plan to me.