u/Adwan4747

Hi there, I have been trying to decode the telemetry for past few days and it took couple attempts but however I got it managed to decode it.

The telemetry downlink is at 437.625 you ofc have to consider the dopper efffect. Throughout the pass I recorded it in wav format and tried to put it though HS_soundmodem but even after multiple attempts and changing the FSK bd multiple times and looping though the audio file I was unable to get anything.

I then installed Conda and miniforge then proceeded with gr-satellities & satnogs and then ran them to get a hexfile JSON & KSS (kiss). I then opened them though SX-TLM-Viewer to get the decoded telemetry and then setup a html page and put all the data in there.

Made a LHCP helical antenna using 1mm copper wire wrapped around a pvc pipe of 6cm in diameter and spacing of 25mm. I tried to follow dereksgc I'm trying to make it for Elektro l3 & l5,GOES 15,Fengyun 2H L-band freq. Also I'm using a 90cm offset dish and there's continuity in the grounding.For some reason I'm also able to pick up local FM broadcast as well. I unfortunately do not have a nanovna so there's no way for me to check the SWR.

Made a LHCP helical antenna using 1mm copper wire wrapped around a pvc pipe of 6cm in diameter and spacing of 25mm. I tried to follow dereksgc I'm trying to make it for Elektro l3 & l5,GOES 15,Fengyun 2H L-band freq. Also I'm using a 90cm offset dish and there's continuity in the grounding.For some reason I'm also able to pick up local FM broadcast as well. I unfortunately do not have a nanovna so there's no way for me to check the SWR.

Made a LHCP helical antenna using 1mm copper wire wrapped around a pvc pipe of 6cm in diameter and spacing of 25mm. I tried to follow dereksgc I'm trying to make it for Elektro l3 & l5,GOES 15,Fengyun 2H L-band freq. Also I'm using a 90cm offset dish and there's continuity in the grounding.For some reason I'm also able to pick up local FM broadcast as well. I unfortunately do not have a nanovna so there's no way for me to check the SWR.

Hey,folks I was testing out my new TYT TH-8000D walkie I bought recently. However, I wanted to see if I would receive anything with my sdr and seems like I'm getting harmonics of sorts? I'm currently using a rtl-sdr v3 with telescopic dipole antenna with length of 49cm each arm.

Got this from a DIY tape measure Yagi antenna I made,I'm not sure what's up with the green thingy at the side I suppose I wasn't tuned into it at the start and did so a sec or 2 later or I suppose SWR issues? I'm not to sure I was also aiming around the proximity of a 5g cell tower as it was a low pass.

Edit: I apologize abt the pic of yagi antenna,that's the only one I had and I had to crop the img.

My apologies for the weird input of the video it seems like I must have run into a problem caused by Reddit or my video editor.

Received by using rtl-sdr and DIY yagi antenna made out of tape measure,at May 9 8:33 AM UTC.

Received my first ever ISS SSTV by using rtl-sdr v3 and DIY yagi antenna made out of tape measure. At May 9 8:33 AM UTC.

Hey guys,received my first ever ISS SSTV today by using rtl-sdr V3 and DIY 4 element yagi made from tape measure.