u/Ast1o

Hey everyone!

​I’m looking to customize my Corne v4.1 build by integrating an Azoteq TPS43 trackpad module over I2C.

​I noticed there are 4 free pin pads on the PCB that could be used for the I2C connection (VCC, GND, SDA, SCL).

​Has anyone wired a TPS43 to this specific board or similar RP2040 setups? Looking for any guidance on the wiring pinout, pull-up resistors if needed, and QMK/Vial firmware configuration to get it running properly. Thanks!

I replaced the sticks with TMR and after inserting, when turning the joystick, the logo backlight changes and my right stick does not work the way it does

Maybe someone knows how to fix it