u/BA_lampman

Managed to accidently pull off a double parry, now I can finally put the game down for good.

Hello everyone,

I need some help with a Helmholtz-Schneider Remote-Field Resonator. Unfortunately, I have to redact the spiral waveform being used as it's not publishable material, but I'm hoping that I can get some guidance regardless.

This resonator is designed to force a Cherenkov cascade by changing the phase velocity of infrared light emitted from the resonator (Fig. B). I have it running between 90-130mHz with an internal electron pressure (vacuum induced) high enough to offset reactor mass by approximately half. I'm avoiding posting actual numbers here but anyone familiar with the setup should be able to approximate them. I won't be going into the material science involved with this high vacuum state - suffice to say that it's a proprietary alloy.

So - the meat of the issue is this: atoms are being trapped within eddy currents around the corona of the sphere (Fig. A) as expected. When EM collapse occurs, electricity is being fed back into the system at a higher rate than it enters. Basic Zero-Kelvin truncation and point energy extraction from virtual time crystals. The issue is that when the machine is turned off the atoms held in the corona accelerate inwards before bouncing back out, but at a reduced mass. We've run this dozens of times and the sensors are picking up every quark and gluon - we're not getting the same amount back is we're putting in.

Has anyone noticed this before? This is supposed to generate energy from field distortion collapse directly from the passage of time, creating a localized bubble of negative entropy, but having matter disappear (where is it going?) gives us pause - is this conversion consuming the atoms held in the eddy currents? Is there some other force at play here that we've missed? I'm confident that our sensor coverage is 100%, so the data is clean, but the interpretation is confounding.

Thanks in advance. If you can clear this up for us we might be interested in having you on retainer as a consultant.

As the title says, I'm looking for a replacement stereo unit for my fiancees new (to her) Rav4. I'm going to try and sneakily install it overnight while she sleeps as a birthday present. I'm not super concerned with installing a rear camera or having the steering wheel controls work - mainly just the touchscreen, bluetooth, maybe calling enabled if that's available.

Do you have any recommendations on the unit? There are a lot of options and I'm not well versed in which ones are reliable, or what extra parts I might need. Thanks!