2024 CB500F Please Help
Please help. 2024 CB500F with led lights.
I installed the Denali T3 rear turn signals and the B6 rear license plate light. The running lights and the brake likes work for the T3 lights. However the amber lights will not illuminate when the turn signal is switched on. The front lights "hyperflash" and the rear ambers do not illuminate at all.
Do I need a load resistor or a turn signal led relay to make these lights function properly?
If I run power directly from the battery to the amber light (green) wire the amber lights up.
I tested for power at the connector with it unplugged. 12v pulse at the plug.
If I reconnect the turn signal connector and turn the turn signal on, stripped back the heat shrink, then put the meter at the bare wire it has no power.
Is the computer being tricked somehow since it draws power to the brake/red running light, then cuts that power when the turn signal is pressed. Atleast it should, so that the amber lights will illuminate.
Or are the lights just not working with my turn signal relay?