u/CaptCoffee2

I had an M1 Max studio working relatively well. I did a migration to a new M5, and it seemed to work pretty much right away, with all my hdmi outputs. But, after some reboots and such, its like the Mac -> atem hdmi connections dont behave. I only get one of the outputs instead of both. Depending on the boot, i might get the main out or the lower 3rds working, but not both. So, I think that satisfies whether its a dongle or cable issue, because one or the other will work. It is an issue in the OSX display manager. It doesnt show them both there either, howeiver it did at first. No number of reboots clear the issue. I tried another dongle and it didnt clear the issue either.

Any idea on this?? I'm hoping to have this resolved by this sunday, but I'm not getting a warm fuzzy about it. Might be without lower thirds.

I have a rough hard surface that keeps overriding my explicit floor type setting of 'Tile'. It wont mop. Even with the settings disabled that are supposed to auto handle floor type. Thing needs to mop. What do I need to do? I deleted the map even, and started over. You can see the tracks where it went show as carpet too. Settings were all off during mapping too. First attemp in the picgture shows the room swept, but it all changed to carpet, and it didnt lower the mop ever.

https://preview.redd.it/00wv8as979ah1.jpg?width=1080&format=pjpg&auto=webp&s=f554cc26e31a39b6c685a60085b8042a208c9920

https://preview.redd.it/5yds4cs979ah1.jpg?width=1080&format=pjpg&auto=webp&s=b797ac9ff89d340b044d857b3dd086342e5a0420