u/CarbonTires

Kind of a very late update since early 2025, so the VRAM chip that was giving errors was replaced including some cracked capacitors near it were too. The gpu is still artifacting at 1080p and will not load drivers at any circumstance and GPUZ is still reporting no memory. Im forced to troubleshoot via hardware now. There could be a short on the decoupling capacitors to the chip, but I am not sure what to measure in that area. I am afraid that the core may be bad. Any help will be good!

Im at a stump right now for where this issue can be located, I just dont want this to be a board issue. Ive tried thermistor replacement, cleaned nozzle, ceramic heater replacement and reseating the USBC cable. Same issue (I have reset the printer here). Only around 300 hours of printing. What can I do?

5 attempts on Duna, 2 crash land. 1st ever attempt attempt on Laythe, landed hard but made it (with 5 iterations of my rocket design) 🗣