u/Creative-Taste-5491

I’m working on getting the flashers functional. The truck has a flatbed with trailer LEDs that stay solid when you hit the turn signal. I’ve replaced what I thought were the front flasher bulbs and still can’t get them to illuminate so I’m trying to troubleshoot one step at a time and disconnected the rear LEDs.

I was able to get *a* turn signal to come on, just not the one I expected. My truck has small rectangular lights behind the grille that I assumed were running lights because they come on when I pull the headlight switch (see the arrow in the picture) but I was getting a slow blink for a few seconds then nothing.

Is this really the turn signal, or do I have a modified setup? And if so is it stock from 1977 or is it an aftermarket addition? They look like they could be from that era but I’m not positive.

Thanks guys!

Hey everyone, I recently bought my first classic truck, a 1977 F250, and I’m getting a lay of the land. There are a couple of components that after going through the manuals I have, I’m still unsure what they are. The one on the driver side had two clipped wires coming from the studs that I removed.

Thanks in advance!

Material is PETG. Printer is Bambu X1 carbon, slicer is Bambu Studios. All slicer settings are default with the exception of supports.

I’m not as familiar printing PETG. I’m seeing these trituration on the flat surface against the build plate, as well as a horizontal seam at about the height the bottom transitions to hollow walls.

Any advice or recommendations how to remove these? Thanks in advance

Material is PETG. Printer is Bambu X1 carbon, slicer is Bambu Studios. All slicer settings are default with the exception of supports.

I’m not as familiar printing PETG. I’m seeing these trituration on the flat surface against the build plate, as well as a horizontal seam at about the height the bottom transitions to hollow walls.

Any advice or recommendations how to remove these? Thanks in advance