u/EchoTheLizard

I need help. I've been having pretty annoying problems with my brand new H2S. For some reason it hates PETG.

I've done flow calibration, flow dynamics calibration, cleaned the build plate multiple times, dried the filament, and used all the calibration options built into it.

I'm getting quite irritated because my P1S seems to do fine without any adjustment but a brand new H2S can't handle normal prints.

Any help is appreciated, and I'd love to have some resources that could teach me more about 3d printing and how to troubleshoot it.

I use the default .16mm High Quality settings for PETG Basic in Bambu Studio.

The problems consist of:

• PETG sticking way too hard onto the build plate, to the point where the only way to remove it was scraping it off.
• Supports were sticking too much to the print, so I added PLA tops but then the bottom of the prints ripped off.
• Supports being knocked off by the Hotend
• Weak prints in general
• Spaghetti nightmare :(

For some reason my avatar that I imported from blender is always facing the wrong direction. I've tried rotating the bones in blender, re-importing it with z forward, rotating it entirely in unity, but nothing seems to work. Any help or tips would be appreciated!