Clock spring wiring diagram
Does anyone have one? My repair manual doesn’t, and I’m not finding it online.
94 4runner, 22re.
My goal is to repurpose the CC buttons for accessories, starting specifically with the on/off button.
I’m not savvy enough with electricity to figure it out on my own, I’ve been trying for hours and can’t seem to make any progress.
I’ve read about people trying it with tacomas I think it was, but that’s a whole different setup. There’s no resistor ladder in my wheel, just a couple wires feeding directly to the switches which IMO means this has to be possible.
The blue wire in the wheel itself is for the horn. On/off switch gets one red and white/black, other red and the green go to the switches on the right side of the wheel.
On the opposite side of the clock spring the wires don’t really coordinate much.
Has anyone else done this?
I thought about going at it two different ways. One: figure out the wiring at the relay in the kicker panel. Or two: figure out the clock spring and cut to patch in my new relay for lights.
Either way I’m confident I can make this work with a little help/guidance/knowledge. Any suggestions are greatly appreciated.
Last picture for attention.