u/G8r8SqzBtl

what else should I change while in there?

obvious bits are dmf bolts, trans bolts, dog mount bolts, axle bolts inner/outer.

how about main seal? crank sensor? anything else?

I havent been on this half of the motor yet but would like to be thorough about it and ideally not have to hunt this deep for a while.

thanks!

has anyone else seen these new potholes leftover from their roadwork? (between fore river parkway and casco bay bridge) you could fit small children in them and there are quite a few of them.

was driving home at night and hit a massive one which put a bubble in the side of my tire.

has anyone had luck with reimbursement? they are directly in line of travel with the wheels and there is no visibility/illumination at night on that stretch

hello, I have a 1998 lx470. from what I can tell these denso gen1 ecus are virtual read only via OBD (I have sm2 pro and vnci nano).

connecting via pcmflash 1.20 w/ module 35, I can see my hw ID (89661-60610) but no sw ID indicated.

Im looking for a bin but cant seem to find one for this hw ID. thoughts on what to do next? Im hoping to get my bin (93 octane) and a bin from a 4x4 tundra (87 octane) and do a comparison to see what strategies toyota used for calibrating the 2UZ FE

any help would be very appreciated. Im new to this arena and eager to learn/try things out.

thanks