u/GDmQh4Jt

I’m not sure if this is a problem after the new software update, but my side view mirrors will not auto tilt when I shift into reverse. I checked the options and the setting is enabled. The only way I can get them to tilt is if I turn the setting off and then back on. Every time I begin a new drive, the mirrors don’t tilt unless I turn the setting off then on. I was wondering if anybody else had the same issue. I submitted a ticket with Rivian.

The United States has bravos stacked on top of each other and they rarely seem to have release issues. I leave out of Venice which nearly doesn’t have to volume of traffic going in and out of New York and get delayed because of ATC. Why does there always see the be hold released out of European airports versus the United States?

Hello All. I recently been approved for a mooring location in Greenwich Cove. I wouldn’t be using this mooring full time since I have a slip in Stamford. It would mostly be used for day trips to have a spot to moor to. Is it worth to have in your opinion to just use periodically? I already received a few quotes from some contractors, I’m not sure if I should pull the trigger on installing the mooring.

My Victron MultiPlus II has been working perfectly with no issues until recently. Now whenever I connect to shore power, the 30A circuit breaker on the dock pedestal trips as soon as the charger kicks on.

I connected to VEConfigure and lowered the shore current limit from 30A down to 20A, but it still trips every time the charger activates. The inverter side seems to work normally when running from the batteries. I already tried using two different cord connections and the same result occurs.

Things I’m wondering:

Could this be a failed charger component inside the MultiPlus II?

Could the AC input side be causing a surge or fault when charging starts?

Is there a way to test whether the issue is the MultiPlus vs. the dock power?

Are there specific VEConfigure settings I should check besides the shore current limit?

What troubleshooting steps would you recommend before pulling the unit or sending it in?

Thanks!