u/Initial_Swordfish914

Hey, just wanted to share my first ever build which was my shed. Prior to this build I didn’t even know what 16 inches on center meant. After extensive reading and YouTubing I present to you my shed!

Note: I messed up and concrete base is a little wide than the actual shed so some water was getting in under the sill. I sealed the interior and exterior with mastic sealant which has stopped 99 percent. Any other ideas to solve this issue?

Thanks for looking everyone.

Hello,

I recently just picked up a dewalt 734 off Facebook marketplace. The outfeed table has rusted a little bit but not through the surface. Does anyone have any recommendations for cleaning this or should I buy a new one for 60 dollars? See photos for details.

Paid 250 which I thought was a great deal. I’m new to wood working so I thought this would be a great beginner tool.

Thank you!

Hello, I’ve never made a cabinet or cabinet door before. This is nothing too fancy but as you can see in the first photo I could not get my blade to cut at an equal depth through the length of the cut.

I cut it using a single blade not a dado stack. I’m not adjusting the blade between cuts. Just finding the center and flipping the board to keep it equal. Curious what the cause of this may be before I start checking alignment and diagnosing the problem myself. The saw is a skilsaw 10inch heavy duty jobsite saw for reference.

Thanks so much in advance!